If Something Does Not Work - Electrolux AEG S 70170 TK38 Libro De Instrucciones

If something does not work

During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart
information is given about them to avoid unnecessary
charges on service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating sound).
This is not trouble, but means normal operation.
We draw it to your attention again that the
appliance operates discontinuously, so the stopping
of compressor does not mean being no-current. That is why
you must not touch the electrical parts of the appliance
before breaking the circuit.
Problem
The appliance does not cool
sufficiently
The appliance cools too
hard
The appliance does not cool
at all
The appliance is noisy
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
Breakdown
The warning signals of the control and signalling system of the appliance are displayed on the visual display. The system will
give out a signal if:
An error has occurred in the operation of the appliance. In case the electronic system of the appliance cannot identify
the real temperature, one of the following signs will appear on the temperature display:
Until the staff of the customer service arrive at the spot and solve the problem, the appliance will continue operating
with the help of a spare program.
Possible cause
Thermostatic control is set too low.
Too many foods to be cooled were put in.
Very warm foods were put in.
Door is not shut properly.
There is no inside cool air circulation.
The thermostatic control is set too high.
Plug is not connected to the mains socket
properly.
There is no voltage in the mains socket.
Thermostatic control is in "0" position.
The appliance is not supported properly.
or
Solution
Set higher position.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Provide inside cool air circulation.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check setting of thermostatic control.
Check if the appliance stands stable (all the
four feet should be on the floor).
GB
39