General Electric IM-6D Instrucciones Para Instalación página 13

INSTALL WATER LINE CLAMP
3
WARNING
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
Attach the metal water line clamp
removed in Step 1, into the cabinet edge through
the clamp and hole in compressor cover.
used for the tubing from the water valve up to the
icemaker.
17
CONNECT THE WATER LINE
4
of the water tube inlet located in the upper-right
rear corner of the refrigerator.
kit with pliers and slide the clamp over the water
tube inlet.
plastic water line into the inlet as far as it will go
Then slide the clamp downward to capture the
plastic water line in place.
Water tube
inlet
B
49-60704-2
Installation Instructions
ELECTRIC SHOCK
HAZARD
Screw
6
ROUTE AND ATTACH THE
5
PLASTIC WATER LINE
Route the plastic water line along the back of the
refrigerator to the water tube inlet.
secure the plastic water line to the case back.
Adhesive-backed
fasteners for
plastic water line
WATER VALVE INSTALLED
6
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
REINSTALL THE COVER
7
Reinstall the compressor compartment access
removed previously to reattach the cover to
the back of the refrigerator case. This must be
reinstalled for your refrigerator to function properly.
13