General Electric IM-6D Instrucciones Para Instalación página 37

ATTACH THE WATER VALVE TO
4
THE MACHINE COMPARTMENT
Locate the female
connector plug. Plug the
female connector onto the
male terminals on the water
valve. Either wire can go on
either terminal.
Fasten the water valve to
the cabinet by driving the
hex-head screw
in the bracket extension and into the hole in the
cabinet.
9
INSTALL WATER LINE CLAMP
5
WARNING
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
Attach the metal water line clamp
the kit through the clamp
the back of the cabinet.
7
be used for the tubing from the water valve up to
the icemaker.
49-60704-2
Installation Instructions
ELECTRIC SHOCK
HAZARD
screw
17
ROUTE AND ATTACH THE
6
PLASTIC WATER LINE
Fasten the plastic water line to the back of the
cabinet with adhesive-backed fasteners
WATER VALVE INSTALLED
7
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
REINSTALL THE COVER
8
Reinstall the compressor compartment access
removed previously to reattach the cover to
the back of the refrigerator case. This must be
reinstalled for your refrigerator to function properly.
5
Adhesive-backed fastener
for plastic water line
37