Seneca K109TC Manual Del Usuario página 10

Voltage Output :
Current Output :
Maximum Voltage :
Maximum Current :
Resolution :
Error :
Static Aux Output :
ADC :
Class/Base Prec. :
Thermal Drift :
Response Time : (10..90 %):
Cold junction error :
Insulation Voltage :
Protection Index :
Operating Conditions :
Storage Temperature :
Altitude :
LED Signalling :
Connections :
Conductor Section :
Wire stripping :
Box :
Dimensions, Weight :
Standards :
0..5 Vdc, 1..5 Vdc, 0..10 Vdc e 10..0 Vdc
Minima load resistance 2 k
0..20 mA, 4..20 mA, 20..0 mA e 20..4 mA
Maximum load resistance 500
approximately 12,5 V
approximately 25 mA
1 mV for voltage output, 2 A for current output
mA or 5 V out put: 350 ppm of the end scale
10 V output : 200 ppm of the end scale
Applicable Voltage : 24 Vac Nominal
Current: 60 mA Max
14 bits
0,1 %
120 ppm/K
< 25 ms (without filter)
< 55 ms (with repeat filter 50 Hz)
1,5 °C Max
1,5 kV (50 Hz for 1 min)
IP20
Temperature -20..+65 °C
Humidity 10..90 % at 40 °C non-condensing.
-40..+85 °C
Up to 2000 slm
Fault/Anomaly, state of the auxiliary output
Spring terminals
2
0,2..2,5 mm
8 mm
PBT (black colour)
6,2 x 93,1 x 102,5 mm, 46 g.
EN61000-6-4/2002 (electromagnetic emission, industrial surroundings)
EN61000-6-2/2005 (electromagnetic immunity, industrial surroundings)
EN61010-1/2001 (safety)
All the circuits must be provided with double insulation from the circuits
under dangerous voltage. The power supply transformer must be built to
compliance with EN60742: "Insulation transformers and Safety
transformers".
Notes:
- Use with copper conductor.
- Use in Pollution Degree 2 Environment .
- Power Supply must be Class 2.
- When supplied by an Isolated Limited Voltage/Limited
Current power supply a fuse rated max 2.5 A shall be
installed in the field.
MI00111 -E 3
m
ENGLISH - 2/8