Heath Zenith SL-6107 Manual Del Usuario página 4

inStaLLation
1. add Jumper at Remote 3-Way Switch.
A jumper wire between the common wire and one of the switched
wires is used to supply power to the SL-6107 regardless of the posi-
tion of the remote switch.
❐ Remove remote switch from the junction box.
The switch may
indicate the common
OR
Color of screw may
be different for the
common
To Red wire of SL-6107
(note color)
Connect Jumper at the Remote Switch
❐ Connect the jumper wire to the common lug (usually labeled on
the switch) and to either one of the two switched lugs. If you're
not sure which lug is common, install the jumper on any two of
the wires, and test the jumper as explained on the next page.
COMMON
-4-
Common Switch Lug
Hot Wire
Jumper
To brown wire of SL-
6107 (note color)
595-4514-14