Vollrath Cayenne FFA7110 Manual Del Operador página 3

OPERATION
WARNING
Fire Hazard
Overheated oil or oil vapors can ignite causing a fire. Monitor
oil temperature, quality and level. Use and maintain oil vapor
removal system.
Heat oil carefully. If oil smokes, reduce heat. Do not leave unit
unattended. If fire occurs, turn unit off, cover until cool. Do not
put water on hot or flaming oil. Do not operate with oil below
low oil mark. Dirty oil has a lower flash point. Replace oil on a
regular basis. Maintain correct oil level. Use an oil vapor
removal system (hood) to red.uce oil and grease buildup on
wall or ceiling surfaces
CAUTION
Burn Hazard
Hot surfaces and food can burn skin. Allow the hot surfaces to
cool before handling. Do not drop or spill water onto the
cooking surface as it can spray or splatter.
Follow these same instructions for each well of a two well unit. Each
well operates independently and may be operated at different
temperatures.
1. Remove basket(s) from fryer.
2. Fill or add oil/solid shorting to the well. Always maintain oil level
between High Oil Level and Low Oil Level as indicated on the side of
the well. DO NOT overfill.
3. Turn the dial to desired temperature; the pilot light indicates when
the elements are energized. If using lard or solid type oil is pulse the
equipment in 1 to 2 minute on and off cycles at low-med
temperature until liquid covers the heating coils. This reduces
smoking and risk of fire.
4. Allow the unit to preheat and the oil to come up to cooking
temperature, approximately 15 minutes. The pilot light will cycle
when the oil has reached the set temperature.
5. Load each basket; NEVER more that half way full.
6. Carefully lower the basket into the cooking oil.
7. When removing the basket from the oil, allow the excess oil to drain
back into the well before transferring to holding area.
Oil Tips
• Use high quality oil.
• Cook at temperatures that are recommended by food manufacture.
• Change oil as needed or food quality requires.
• Skim oil often and filter daily.
• Cover oil overnight.
TROUBLESHOOTING
Problem
Pilot light does not illuminate when
the temperature control is turned up
Oil gets too hot
Oil does not get hot enough
Oil heats slowly
Oil boils over top when frying
®
Cayenne Standard-Duty Electric Countertop Fryers Operator's Manual
Might Be Caused By
Fryer is not plugged in.
Safe operation switch in "OFF" position. Check the safe operation switch is in "ON" position.
Temperature safety switch is tripped.
Pilot light malfunction.
Oil level low.
Thermostat control malfunction.
Thermostat control malfunction.
Low or incorrect voltage to fryer.
Too much oil in the well.
Too much food in the basket.
Too much water in the food.
CLEANING
WARNING
Electrical Shock Hazard
Keep water and other liquids from entering the inside of the
equipment. Liquid inside the equipment could cause an
electrical shock. Do not spray water or cleaning products.
Liquid could contact the electrical components and cause a
short circuit or an electrical shock.
CAUTION
Burn Hazard
Hot surfaces and food can burn skin. Allow the hot surfaces to
cool before handling. Do not drop or spill water onto the
cooking surface as it can spray or splatter.
To maintain the appearance and increase the service life, clean your
equipment daily.
1. Allow the unit and oil to cool completely before cleaning.
2. Unplug the unit.
3. Do not immerse the cord, plug or controls in water or any other
liquid.
4. Rotate the fryer head to the up position.
5. Carefully remove the well(s) from the unit and then filter or discard
the used oil.
6. Use a damp cloth or sponge dipped in soapy water to clean the unit
and well(s); rinse thoroughly. Or, fill the well(s) with water and dish
washing liquid. Lower the fryer head to the down position and boil
for a few minutes; rinse thoroughly.
NOTICE: It's important that the unit doesn't run dry as it will cause
the element to burn out.
7. Dry thoroughly after cleaning.
Course of Action
Plug in fryer.
Reset temperature safety switch.
Replace pilot light.
Turn off the fryer and allow it to cool. Add oil to proper level.
Replace thermostat control.
Replace thermostat control.
Verify that voltage rating on fryer matches the source voltage. If not,
have qualified electrical personnel install proper source voltage.
Reduce the amount of oil in the well.
Reduce the amount of food in the basket.
Dry food product or remove ice crystals from food prior to frying.
3