Disposal; Checklist For Start-Up - Reer SAFECODER Instalación Uso Y Mantenimiento

10.1 Disposal

Always dispose of unusable or irreparable devices in compliance with the waste disposal
regulations in force. We will be glad to help you for disposing of these devices.
Please contact ReeR for this.

11. Checklist for start-up

Mounting (for information, see Mounting Advice)
The encoder must only be installed using the fixing elements supplied by

the ReeR SpA company.
 The loading on the encoder shaft, as a result of mounting/installation, is
to be kept as low as possible. The installation dimensions specified of the
encoder, must be strictly observed. It is also important to note that the
tolerance compensating elements must be mounted without pre-loading.
 The indicated torques for mounting the encoders and the fastening
elements have been complied with.
 Axial and radial offset are to be kept to a minimum during installation, so
that the specified maximum values are not exceeded.
The shaft tolerance of the drive shaft, onto which the encoder is fitted, is

stipulated as G6 (for solid shaft encoders)/G6 (for hollow shaft encoders).
Electronic connections (see data sheet for terminal assignment)

Is the signal level and polarity of the supply voltage correct?
Have the sine/cosine signals been correctly wired with respect to polarity

and phase?

Terminating resistor 120 Ohm (A
Controller

Do the direction of rotation and count direction match?

Sin (x) + Cos
2
12
(x) = 1 monitoring been activated?
2
SAFETY SINE/COSINE INCREMENTAL ENCODER
; B
– – )
Ā
8540939 - 05/2013 - Rev.0