Light Kit Assembly. Pgs - Ellington Craftmade MR56ESP4C1 Guia De Instalacion

9. Light Kit Assembly.
Remove 4 decorative nuts from switch housing
plate - save for later use.
Remove 1 screw from fitter plate on underside of
motor housing and partially loosen the other 2
screws. Align slotted holes in switch housing plate
with loosened screws in fitter plate, allowing the
male plug from motor housing to come through
hole in middle of switch housing plate. Twist switch
housing plate to lock. Re-insert screw that was
previously removed and securely tighten all 3
screws with a Phillips screwdriver.
Remove 1 screw from post located in middle of
switch housing plate and partially loosen the other
2 screws. Connect male plug (large) from motor
housing to female plug (large) from the light kit
fitter. Connect male plug (small) from the switch
housing plate to female plug (small) from the light
kit fitter. Align slotted holes in light kit fitter with
loosened screws in switch housing plate. Twist light
kit fitter to lock. Re-insert screw that was previously
removed and tighten all 3 screws securely.
Remove finial, finial plate and threaded washer
from light kit fitter.
Install 3 candelabra base 40 watt max. bulbs
(included).
Important: When replacing bulbs, please allow
bulb(s) and glass shade to cool down before
touching them.
["Light Kit Assembly" continued on next page.]
fitter plate
switch housing plate
male plug (large)
female plug (large)
bulb
page 7
switch
housing
plate
wire
housing
decorative nuts
motor housing
male plug (small)
female plug (small)
light kit fitter
threaded washer
finial plate
finial
switch
housing
plate