Fan Assembly. Pgs - Ellington AVL56BNK5RW Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of your fan, you
must remove the hanging ball from the 6in. downrod
provided to use with an extended downrod (sold
separately). [If you wish to use the 6in. downrod, please
proceed to instructions following the dotted line below.]
To remove hanging ball, loosen set screw on hanging ball,
lower hanging ball and remove stop pin. Slide hanging
ball off the original downrod, A, and slide it down the
longer downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole when
setting the set screw). Insert stop pin into top of extended
downrod and raise hanging ball. Be sure stop pin aligns
with slots on the inside of the hanging ball. Tighten set
screw securely.
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the ends
of the electrical wires--this will keep the wires together
when threading them through the downrod.
Locate canopy cover in hardware pack. Loosen yoke set
screws and nuts in motor housing yoke and remove pin
and clip from motor housing yoke. Slide downrod through
canopy, canopy cover and yoke cover. [Note: Canopy cover
must be turned with shiny side toward the motor
housing.]
Thread safety cable and electrical wires through downrod
and pull extra wire slack from the upper end of the
downrod.
Place downrod into the motor housing yoke and re-insert
pin and clip. Securely tighten yoke set screws and nuts.
Lower yoke cover to motor housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
electrical wiring
downrod
canopy
yoke cover
clip
page 4
set screw hole
stop pin
hanging ball
A
safety cable
canopy cover
yoke set screw
and nut
B
pin
motor
housing