4
8
5
6
A
4
- Position the case on the vehicle (see marking).
-
Position the case parallel to the center of the vehicle.
-
Position the case (included) on the case rail (5).
Then push the case forward until the case is firmly seated on the
case rails, and the case hook (6) is firmly seated in the case holder
of the motorcycle. (See Figure A)
- Swivel in the locking lever (4).
- Return the key to the locked position.
NOTE:
If it is impossible to swing in the locking lever (4), the case is not yet
engaged in the forward-most position or the key is not in the right position.
- Key position: 45° to the left: The case can be removed.
The key cannot be pulled out in this position.
- Key position: straight (as shown): The case is locked.
The key can be pulled out in this position.
- Key position: 90° to the right: The case can be opened.
The key can be pulled out in this position.