Wiring - Elkron EL60RT 2PH Manual De Instalación

2
1
1 Test button (only RX)
2 DIS OUT (only RX)
3 Terminals
4 DIS ON (only RX)
5 Channel selector
6 Tmp 1
7 Tmp
20

4. WIRING

3
7
When pressed allows you to access the functions of alignment
In case of disqualification activated gives output signal (NEGATIVE
OPEN COLLECTOR). Jumper not inserted: to be wired to the central
unit through a flying terminal
Alarm contact
N.C. (only RX)
With inserted jumper enables the environmental disqualification and
the monitoring output Dis Out (inserted by default)
Moving the dip switch in ON (one at a time) enables a transmission
channel, the same set to the TX must be corresponding to that of the
RX (CH1 by default).
Tamper input additional, in case of absence MUST remain closed by
jumper (inserted by default)
Tamper anti cover removal
EL60RT 2PH 60m
EL120RT 2PH 120m
5
TAMPER
Power supply
Contact
10 – 30 Vdc (RX and TX)
RX - TX
6
4