Frequency Selection; Allignment Test - Elkron EL60RT 2PH Manual De Instalación

CHANNELS 1
1 2 3 4
ON
To compose barriers or dams with more than one pair of receivers/transmitters, it is necessary to avoid
interference assign a different channel to each of them. To do this you must turn ON the dip switches on the
desired channel on the mother board. The channel will be the same from both the transmitter and the receiver
(ex. CH_TX1/CH_RX1 – CH_TX4/CH_RX4).
Press the TEST button on the RX mother board for 3 seconds until the buzzer will beep twice, accompanied
by two blinking of LEDs, to begin calibration.
1. Press the TEST button on the RX Column
2. Power on of buzzer and LEDs on RX column

5. FREQUENCY SELECTION

CHANNELS 2
1 2 3 4
ON

6. ALLIGNMENT TEST

EL60RT 2PH 60m
EL120RT 2PH 120m
CHANNELS 3
1 2 3 4
ON
CHANNELS 4
1 2 3 4
ON
21