LeakSmart Waxman 8810100 Manual De Instalación Y Funcionamiento página 5

LeakSmart Washing Machine Kit
Installation Instructions:
5. Lightly wrench tighten all connections 1/4 turn, or until
snug. Do not over tighten.
6. Turn on the hot and cold shut-off valves and
check for leaks.
5.
6.
8.
Installation Instructions:
7. Mount the LeakSmart Control Panel in an easily
accessible location within 30 inches of the LeakSmart
Valves. You may mount the panel using the screws and
anchors or Hook & Loop Mounting Pad provided. When
using the Hook & Loop Mounting Pad, make sure the
adhesive is put on a clean, dry surface.
NOTE: Depending on the location you pick, and the
distance between the hot and cold shut-off valves, you may
need to purchase two (2) LeakSmart Control Panel to Valve
Extension Wires, Model #8821200 (sold separately, available
where you purchased your LeakSmart System). The
extention wire can extend the leghth of the LeakSmart valve
wires by approximately 9 feet.
8. With the contacts of the Wire Harness connector facing
you, plug the 6-pin connector end of the Wire Harness
into the bottom of the Control Panel.
LeakSmart Washing Machine Kit
7.
8.
9.