LeakSmart Waxman 8810100 Manual De Instalación Y Funcionamiento página 6

LeakSmart Washing Machine Kit
Installation Instructions:
9. Take the 2 short round wires coming from the Control
Panel and connect each one to the wires coming from
the LeakSmart Valves (make sure the arrow on the side
of the plugs line up with each other). It does not matter
which wire gets connected to which LeakSmart Valve.
NOTE: The LeakSmart Water Leak Sensor comes with a
paper sleeve. If the Leak Sensor is going to make contact
with the washing machine, or any other piece of metal, make
sure you leave the paper sleeve on. If the Leak Sensor makes
contact with metal, it will signal the LeakSmart Valve to shut
off. The paper sleeve acts as a barrier between the Leak Sen-
sor and the metal. When the paper sleeve becomes wet, it
will signal the LeakSmart Valve to shut off. If the Leak
Sensor will not be contacting metal, you may remove the
paper sleeve.
10. Connect plug on end of long flat wire coming from
Control Panel to either set of prongs on the Leak Sensor,
pushing until plug snaps in place. Then place the Leak
Sensor on the floor behind the washing machine.
NOTE: Additional Water Leak Sensors (sold separately) can
be connected together for added protection. For additional
Leak Sensors, purchase LeakSmart Water Leak Sensor,
Model #8820700 (available where you purchased your
LeakSmart System).
CAUTION: Do not place Leak Sensor or cord in a walkway, or
other location that may cause someone to trip and fall.
9.
10.
10.
Installation Instructions:
11. Plug the pin on the end of the AC Power Adaptor cord into
the bottom of the Control Panel, and then plug the AC Power
Adaptor into the nearest 110 volt wall outlet. Green indicator
lights will start to flash, showing you have power. Note that
a red low battery indicator light will also flash about every
30 seconds, and the unit will beep approximately once a
minute until fresh batteries are installed.
NOTE: If a nearby wall outlet is not available, you will need to
purchase a thin low voltage LeakSmart AC Power Adaptor
Extension Wire, Model # 8821100. This extension wire is sold
separately (available where you purchased your LeakSmart
System). This wire extends the length of the AC Power Adaptor
cord by approximately 9 feet.
NOTE: It is recommended that you do not plug the AC Power
Adaptor into an extension cord. The LeakSmart kit comes
with a 6 ft. AC Power Adaptor Cord. A 9 ft. AC Power
Adaptor Extension Wire is also available (sold separately) that
can provide a total length of 15 ft. for the AC Power Cord supply.
12. LeakSmart has a battery backup system that allows the unit
to continue working in the event that you have a power
outage. To set up the battery backup system, open the front
of the Control Panel and install 4 fresh AA alkaline batteries
(batteries not included). The low battery indicator light will
now stop flashing and the beep will stop.
CAUTION: Replace batteries once a year or sooner as
necessary. If batteries need to be changed sooner, a red low
battery indicator light will flash, and a beep will sound.
LeakSmart Washing Machine Kit
11.
12.
NOTE: The Control Panel will
continue to beep approximately
every minute until 4 fresh AA
batteries are installed.
11.