Troubleshooting - LeakSmart Waxman 8810100 Manual De Instalación Y Funcionamiento

LeakSmart Washing Machine Kit

Troubleshooting

Problem
Status light does not light
LeakSmart Valves closed but now will not open
The alarm goes off for no apparent reason
What to Check
- Make sure there is power to the outlet.
- Unplug AC Power Adaptor cord from
Control Panel and plug back in.
- If AC Power Adaptor Extension Wire was
used, unplug both ends and reconnect.
- Make sure fresh batteries are in the Control
Panel.
- Make sure both sides of Leak Sensor are
dry.
- Leak Sensor is touching metal, or the
concrete is sweating causing high humidity.
Correct the problem by placing the paper
sleeve on the Leak Sensor, or use a paper
towel as a barrier.
14.
Troubleshooting
Problem
Only one LeakSmart Valve operates
Neither LeakSmart Valve operates
Continued next page
LeakSmart Washing Machine Kit
What to Check
- Unplug 6-pin connector from Control Panel
and reconnect.
- Locate plug connection between Control
Panel and the LeakSmart Valve that does
not operate. Unplug the connection and
reconnect, making sure arrows on side of
plugs line up.
- Push the Close button and wait a few
seconds. Then push the Open button.
- Make sure both sides of Leak Sensor are dry.
- Make sure there is power to the outlet.
- Unplug AC Power Adaptor cord from Control
Panel and plug back in.
- Unplug 6-pin connector from Control Panel
and reconnect.
- Locate plug connection between Control
Panel and each of the LeakSmart Valves.
Unplug both connections and reconnect,
making sure arrows on side of plugs line up.
- If an AC Power Adaptor Extension Wire was used,
unplug both ends and reconnect.
- Make sure fresh batteries are in the Control Panel.
15.