Troubleshooting - Dri-Eaz Ace TurboDryer Manual Del Propietário

SPECIFICATIONS
Model
Operating Positions
Power, 115 Volts
Actual CFM
RPM
Static Pressure
Motor Rating
Motor Speeds
Thermal Protection
Switch
Fan Blade
Height, Width, Length
Use Weight
Ship Weight
Stackable
Handle
Cord Length
Safety Listings
Warranty
Specifications are subject to change without notice. Some values are approximate.

TROUBLESHOOTING

In COLUMN 3, the technician in the field can handle "FS" or Field Solutions. Others solutions should be handled by a repair technician – an
"AST" or Authorized Service Technician.
WARNING: Execute all the service procedures below only with power turned off, i.e. unplugged.
PROBLEM
Motor won't run
Motor runs but blade turns
erratically or scrapes
Unit vibrates excessively
FOR PARTS AND SERVICE CALL YOUR LOCAL DISTRIBUTOR,
or the Dri-Eaz Service Department at (360) 757-7776
07-01475 C 12-02 Copyright 2002, Dri-Eaz Products, Inc.
Ace TurboDryer
6
1.5 amps
1,954 (3320 CMH)
1670 Low - 1756 High
0.6" (1.5 cm)
1/4 hp. TEAO
2-Speed PSC
Thermal Cut-off
2-Speed Rocker
16.5" Axial (41.9 cm)
24 x 20.3 x 19" (61 x 51.5 x 48.3 cm)
33 lb (15 kg)
38 lb (17 kg)
Yes
Molded
25 ft (7.6 m)
UL, C-UL
7 Year Limited
CAUSE
No power to machine
Switch not turned on
Fan blade jammed
Intake or exhaust grill blocked
Switch is broken
Loose wiring
Severe jolt has caused motor mount to
bend and fan blade to rub
Accumulation of soil on fan blade
Fan blade has lost balance
Fan blade has been bent
Bent motor shaft
See
above SOLUTION
FS Plug in the unit; check circuit breaker or fuse
FS Turn on the switch
FS Remove material jamming balde
FS Turn machine off and allow to cool, then remove blockage
AST Call distributor or Dri-Eaz for replacement switch
AST Check wiring and tighten as needed
AST Remove motor from housing, then replace or repair bent motor
mount
FS Clean fan blade
AST Balance or replace fan blade
AST Replace fan blade
AST Replace motor
4