Troubleshooting - Panasonic DMW-FL220 Instrucciones De Operación

Troubleshooting

∫
Q&A for the unit
The unit becomes hot.
This unit will generate heat when light is continuously emitted right
after the [CHARGE] lamp lights up. However, the performance and
quality of this unit will not be affected as long as continuous light
emission does not exceed 10 times.
In cases like this, wait until the flash head and batteries cool off
before resuming use.
You can't install the unit on your digital camera.
Did you loosen the lock ring? (P11)
The unit cannot be attached to a digital camera unless the lock ring
is loosened.
The flash is not activated.
≥ Is [CHARGE] lamp lit up?
≥
Light may not be emitted if the flash is attached incorrectly.
[CHARGE] lamp is lit up but light is not emitted by pressing
[TEST] button.
The unit is waiting for communication with the digital camera.
In this case, switch the mode dial of this unit once. If you are using
a digital camera with a communication function, turn on the digital
camera again.
The colouring of the images differs from what I see.
Adjust the white balance of the digital camera.
The recorded picture is too bright or dark.
≥ Is there a subject within the flash working range? Adjust the
flash light amount, aperture, and ISO sensitivity etc. of the digital
camera according to the distance to the subject.
≥
Check the mode dial on this unit.
16
VQT1U62
The flash's power does not go off even though I turned off the
power of my digital camera which comes with communication
functions.
Power is not connected with the digital camera.
Turn off this unit by setting the mode dial to [OFF].