Stalgast 9732010 Manual De Instrucciones página 60

1. CHARACTERISTIC OF THE DEVICE
The housing is made of stainless steel. The tabletop is mounted on a base with four feet, by means of which
you can level the lava grill. Leveling is possible within the range of ±10mm.
The main components of the device include: worktop with grate, gas valve and main 6.5kW burner.
The panel behind the door contains a gas valve, a spark generator and a drawer for waste from the grate
and burnt stones.
The device is equipped with a set of nozzles
2. GRILL INSTALLATION
•
The lava grill should be placed on a stable surface in a closed room with the power off. Then level the
appliance by means of the feet in the body or the base of the lava grill
Place the appliance so that it is accessible at least from the front. There should be a wall made of non-
combustible materials behind the device.
•
The device can be set up in a row of appliances. If the appliance is not set up in a row with other devi-
ces of the same line, the walls adjacent to the appliance (rear and side) should be made of non-combu-
stible materials.
•
The power outlet should have an up-to-date readings related to electric shock protection.
•
The appliance is sold for a specific type of gas, as certified on the rating plate. Any change
to the type of gas can only be made by a qualified and authorized installers and must be
included in the warranty card attached to the appliance. The devices sealed and protected
by the manufacturer could only be handled by qualified installers after authorization and
training provided by the Technical Service of STALGAST.
3. CONNECTION
3.1. CONDITIONS FOR CONNECTION TO MAINS:
•
You must check if voltage in grid is equal to the grid indicated on device's rating plate
•
To plug the device in electricity network you must perform plugging of the power cord in the terminal
box placed on the back wall of the device. The power cord with a plug IS NOT the part of the set
and you must buy it.
•
You must necessarily join the device to the installation of equalising electrical potentials with the help of
equipotential bolt placed in the back of the device. It is marked by the following symbol:
To join the device to the installation of equalising electrical potentials, you must:
•
Remove the nut from the bolt
•
Introduce equpotential's cable
•
Tighten the nut until it stops
•
You must plug the second end of equipotential cable in the countervailing rail.
Connection of the device with installation of equalising electrical potentials.
The power cord should be flexible, oil-resistant, earthed, polychloroprene-coated (type H07RN-F 3G1.5
2
mm ). It can be made by the manufacturer and available from him or in specialist repair shops!
Adjustable foot
- 62 -