1.1 Introduction; Getting To Know The Machine; Unpacking; Standard Machine Equipment - Ghibli FRECCIA 15 Uso Y Mantenimiento

EN

1.1 INTRODUCTION

HAZARD:
Before using the machine, carefully read the
attached "SAFETY WARNINGS FOR THE
FLOOR SCRUBBER DRYER" manual.
2.1 GETTING TO KNOW
THE MACHINE (Fig. 1)
1) Guide handle.
2) Control console.
3) Floor washing operating pedal.
4) Lever for starting brush rotation and/or
dispensing water.
5) Lever for rotating handle positions.
6) Recovery water tank.
7) Recovery water tank cover.
8) Power cable (for E version only).
9) Clean water tank.
10) Clean water filling opening.
11) Wheels.
12) Brush rotation flange.
13) Brush.
14) Squeegee.
15) Recovery water drain hose.
16) Squeegee water aspiration hose.
17) Battery charger (for BC version only - not
for version BC Long Run).
18) Batter charger indicator (for BC version
only - Not for version BC Long Run)
19) Water regulation tap.
20) Water filter.
21) Plug/batteries socket(for BC Long Run
version only).
22) Parking/brush pressure
wheel.
23) Angle adjustment handwheel.
24) Battery charge status LEDs.
25) Aspirator button.
26)Brush rotation button.
27)Water delivery button.
3.1 UNPACKING (Fig. 2)
Once the packaging has been removed as
shown in the instructions on the packaging it-
self, check that the machine and all the com-
ponents supplied are intact.
If any evident damage is found, contact the
area agent and the carrier within 3 days of
receipt.
- Remove the pack (28) containing the ac-
cessories supplied and the box (29) con-
taining the brush.
3.1.a - Standard machine equipment
(Fig. 3)
The accessories supplied are as follows:
30) Water filling hose.
31) Machine use and maintenance manual.
32) Battery charger instruction manual.
33) Filter for clean water tank opening.
34) 30A fuse.
35) Brush.
36) Charger (BC Long Run version).
37) Cord with snap hook (version E).
38) Tear-proof hook (E version).
4.1 ASSEMBLING THE
4.1.a - Positioning of the handle (Fig.
4)
- Unlock the handle (1) pulling the lever (5)
and lift it placing it in the desired position.
adjustment
4.1.b - Connecting the batteries (for
BC version only) (Fig. 5)
- Unscrew the screw (39) that fixes the
tank (6) to the handle support.
- Remove the recovery water tank (6) and
connect the battery connectors (40) and
(41).
- Replace the recovery water tank (6).
EN-4
COMPONENTS