Lever For Handle Angle Regulation; 7.2 Machine Handling; 8.1 Filling The Tank - Ghibli FRECCIA 15 Uso Y Mantenimiento

25) Aspirator button
On pressing the button (25) it illuminates
and the functioning of the aspirator starts.
The functioning of the aspirator is ena-
bled by pressing the button (26).
26) Brush rotation button
On pressing the button (26) it illuminates
and tension is fed to the circuits and rota-
tion of the brush.is enabled.
The starting of rotation of the brush is
controlled by pressing levers (4).
27) Water dispensing button
On pressing the button (27) it illuminates
and enables the dispensing of water for
washing pavement.
The dispensing of water is controlled both
by the switch (26) and by pressing the le-
vers (4).
4) Brush rotation and/or water dispens-
ing lever
Pressing the levers (4) and holding them
pressed, starts the rotation of the brush
and, if enabled, the dispensing of water.
7.1 LEVER FOR HANDLE
ANGLE
REGULATION (Fig. 10)
- By pulling on the lever (5), it is possible to
vary the position of the handle (1);
releasing the lever, the handle is posi-
tioned and locks in the nearest required
position.
N.B.:
By positioning the handle (1) vertically, it is
possible to effect a more thorough cleaning
of corners by rotating the machine on itself.

7.2 MACHINE HANDLING

(Fig. 1)
- To move the machine, lift the wiper (14)
and place the wheel (22) in the parking
position as indicated in the respective
paragraphs.
- Move the machine by pushing its handle
(1).

8.1 FILLING THE TANK

(Fig. 11)
WARNING:
Only add clean mains water to the tank at
a temperature no greater than 50°C.
- Remove the hose (30) supplied, connect
one end (30a) to a tap and insert the oth-
er end (30b) in the tank (9).
- Turn on the tap and fill the tank (9).
- Pour the liquid detergent into the tank.
N.B.:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
DANGER:
If the detergent comes in contact with the
eyes and/or skin or if swallowed, refer to
the use and safety information booklet
provided by the manufacturer of the de-
tergent.
- Once tank filling is complete, it is possible
to:
Insert the hose (30) into the tank (9) fully
where the end (30a) acts as a cap; or re-
move the hose (30) fully and insert the
filter (33) supplied into the tank (9) open-
ing.
EN-7
EN