Performance BUILT LGS13 Instrucción & Ensamblaje página 8

STEP 3: Attach Control Valve Handle
1. Insert the control valve handle into the base and secure handle with a 10mm wrench.
STEP 4: Change Engine Position
1. Engine needs to be moved away from the cylinder to operate correctly. Loosen the hex bolt
M10x45, lock washer Ø10 and hex nut M10, slide the engine out away from the cylinder and
retighten the hex bolt, lock washer and nut.
Engine must be moved away from the cylinder to operate correctly. Failure to follow this
instruction may result in voiding the warranty on the log splitter.
WARNING
- 8 -
Move the Engine out away
from the Log Splitter.