Philips FC8778 Manual Del Usuario página 20

English
22
Problem
The robot does not clean
properly.
The rechargeable battery
can no longer be charged
or runs empty very fast.
The robot is moving in
circles.
Possible cause
The robot was lifted while it
was cleaning.
The bristles of one or both
side brushes are crooked or
bent.
The filter in the dust
container is dirty.
The suction opening in the
bottom of the dust container
is clogged.
The front wheel is jammed
with hair or other dirt.
The robot is cleaning a very
dark or shiny surface, which
triggers the drop-off sensors.
This causes the robot to
move in an unusual pattern.
The robot is cleaning a floor
that reflects sunlight quite
strongly. This triggers the
drop-off sensors and causes
the robot to move in an
unusual pattern.
The rechargeable battery has
reached the end of its life.
The robot is in spot-cleaning
mode.
Solution
Place the robot on the floor. Then press
the start/stop button briefly to make the
robot resume cleaning.
Soak the brush or brushes in warm water
for a while. If this does not restore the
bristles to their proper shape, replace the
side brushes (see 'Replacing the side
brushes').
Clean the filter in the dust container with a
cloth or a toothbrush with soft bristles. You
can also clean the filter and dust container
with a regular vacuum cleaner at a low
suction power setting.
If brushing or vacuuming does not help to
clean the filter, replace the filter with a
new one. We advise you to replace the
filter at least once a year.
Clean the suction opening (see 'Cleaning
the robot').
Clean the front wheel (see 'Cleaning the
robot').
Press the start/stop button briefly and
then move the robot to a lighter colored
piece of the floor. If the problem continues
to occur on lighter colored floors, please
go to www.philips.com/support or contact
the Consumer Care Center in your country.
Close the curtains to block sunlight from
entering the room. You can also start
cleaning when the sunlight is less bright.
Have the rechargeable battery replaced by
a Philips service center (see 'Replacing the
rechargeable battery').
This is normal behavior. The spot-cleaning
mode can be activated when a lot of dirt is
detected on the floor for a thorough clean.
It is also part of the auto cleaning mode.
After approximately one minute the robot
resumes its normal cleaning pattern. You
can also stop the spot-cleaning mode by
selecting a different cleaning mode in the
app.