Using Your Smartmedia Card - Philips XP SA 107 Manual Del Usuario

XP SA 107/17 11-07-2000 11:11 Pagina 9
AC/DC ADAPTER
1 Make sure the local voltage corresponds to the 4.5 V
adapter's voltage. The 1.3 mm center pin (in the 4.5V DC
jack on the set) must connect to the positive pole + of the
supplied adapter with 3.5 mm jack.
2 Connect the adapter to the set's 4.5V DC jack and a wall
power outlet.
™
message may appear briefly on the display.
3 Always disconnect the adapter from the AC wall power
outlet if you are not using it.

USING YOUR SMARTMEDIA CARD

(See Fig. 1 on page 3)
You can store up to 120 minutes of music on the card, erasing
and overwriting as you want.
Make sure the set is off before inserting or removing the card.
• Insert a SmartMedia card into CARD INSERT with the
clipped corner of the card aligned as shown on the set.
Display shows:
™
– if your card is blank.
™ card details if card already contains files.
™
– if format is incompatible with the set.
™
– the track is not an audio track or your card is
blank.
• Ejecting: Slide the CARD EJECT switch up and remove the
card.
9