Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Wall mounting
Warning:
• Make sure to use two screws for hanging the
charger on the wall, and anchor the charger on the
wall with another screw.
Otherwise the charger may fall and cause serious
injury.
• Always be sure that the charger is unplugged and
all the batteries are removed from the charger
before performing wall mounting work.
• Follow the steps instructed in this manual, and
complete the whole procedures at once. The
charger may fall and cause injury or damage if you
stop the work in the half way.
• Check tightness of the screws on regular basis.
Otherwise the charger may fall because of loosen
screw.
• Clean the terminal parts of the charger on regular
basis with an air duster etc.
Caution:
• Carefully choose a stable wall for mounting the
charger.
Make sure there is no hindrance to mounting
work or charging operation. The gross weight
of the charger and battery reach approximately
2.3 kg (5.0 lbs). Provide sufficient reinforcement for
the wall if necessary.
Things you need to prepare:
– Two screws - for hanging the charger. (Fig.3)
Screw size : 4mm x more than 20mm
(5/32" x more than 13/16").
Screw head size : Less than ø9.0mm and less than
3.5mm thickness.
(ø11/32" x 1/8").
– One screw (4mm (5/32") x more than 25mm (1")) - for
anchoring the charger. (Fig.4)
– Tools - for tightening screws.
You can mount the charger on the wall. Make a clearance
around the charger as shown in the figure. (Fig.2)
1.
Fix two screws for hanging on the wall. (Fig.3)
2.
Hang the charger on the wall using the hook on the
back.
3.
Fix the charger by tightening an anchor screw at the
top of the charger. (Fig.4)
5
Publicidad
Tabla de contenido
