Power Supply; Starting The Appliance - babymoov Yoo-See Instrucciones De Uso

A. CAMERA
The camera works on main power with the 5V power adapter supplied.
Connect the adapter's output jack to the micro USB port (6) of the
receiver, making sure it is properly positioned.
Plug the adapter into the wall socket, the LED (7) will be green.
B. RECEIVER
1. Operation with rechargeable battery.
The 3.7 V 850 mAh Li battery is already installed in the receiver.
Plug the adapter to the USB port (19) making sure it is properly positioned.
The power light indicator (11) is green if the receiver battery is sufficiently recharged.
N.B. : Before using the receiver for the first time, charge the Lithium battery using the power adapter for at least 5 hours.
2. Battery status
When on and charged, the power light indicator (11) is green. The icon
battery's charge level.
When the battery is low, the power light indicator (11) and the battery level icon are red.
When the battery is very low, the power light indicator (11) flashes red and a sound
signal goes off. Your babyphone will soon switch itself off. Remember to charge your
babyphone's battery
3. Recharging the battery
You can recharge the battery when the receiver is switched on. Connect the adapter to the USB port (19) making sure that
it is properly positioned and connect the receiver to a wall socket. The power light indicator (11) will flash green.
You can also recharge your receiver when it is off. The power light indicator (11) will turn to orange and the battery level icon
will be displayed on the LCD screen (10) for 30 seconds and will indicate that the battery is recharging.
N.B. : Remember to disconnect the power adapter once the battery is completely recharged. To extend battery life and for
better autonomy, wait for it to run flat before recharging.
WARNING: MAKE SURE THAT THE BATTERY IS CORRECTLY INSERTED INTO THE RECEIVER BEFORE
CONNECTING THE POWER ADAPTER TO THE MICRO USB PORT TO AVOID ANY EXPLOSIONS.
ONLY USE THE ORIGINAL BATTERY OR ONE SUPPLIED BY THE DEALER.
KEEP THE BATTERY OUT OF REACH OF CHILDREN.
1. Place the camera on a flat surface between 1m and 2.50 m from the baby's head. Point the camera lens(1) and the
microphone (5) towards the baby.
2. You can fix the camera to the wall using a wall-mounting kit and tilt it from the top down and on the sides to improve visibility.
3. Switch the receiver on by pressing the start button(18) until the power light indicator (11) is green. The image captured
by the camera lens must appear on the screen with the sound transmitted by the microphone. If the screen displays the
"disconnected" image
or the connection between 2 appliances has been broken (see CONNECTION OF THE CAMERA TO THE RECEIVER).
4. Once on, your babyphone has a sound and visual alarm (the LEDs (15) come on) to warn you when baby makes a noise.
5. The sensitivity of the microphone and the volume of the speaker can be remote controlled from the receiver menu. This
corresponds to the VOX mode (see USE OF RECEIVER CONTROL PAD).

POWER SUPPLY

STARTING THE APPLIANCE

and transmits a sound signal, it means that the appliances have not been correctly connected
YOO-SEE BABYPHONE • Instructions for use
indicates the
EN
13