Replacing A Display Light; Options And Accessories - Hatco FLAV-R-SAVOR FSD Serie Manual De Instalación Y Funcionamiento

Replacing a Display light

WARNING
Make sure protective lamp cover(s) are installed in front of
fluorescent lamp(s). Breakage of fluorescent lamps not
properly protected could result in personal injury and/or
food contamination.
The unit is equipped with two fluorescent lamps that illuminate
the warming area. These lamps have a special lamp cover to
guard against injury and food contamination in the event of
breakage. When replacing a fluorescent lamp, use P/N
02.30.074.00. Use the following procedure to replace a
fluorescent lamp.
102 mm (4") adjustable legs
The 102 mm (4") adjustable legs are used to add additional
height to the unit.
1. Secure all glass sides and doors with tape. Lay the unit
onits side. NoTICE: Do not lay unit on side with
controlpanel.
2. Remove the four screw-type rubber feet from the
cornerbrackets.
Rubber
Foot
4" Leg
Figure 12. Installation of 4" Legs
3. Screw the 4" (102 mm) legs into the holes in the middle of
each corner bracket. After all the legs are tightened, return
the unit to its upright position. If the unit is not level or rocks,
turn the adjustable tip of the appropriate leg to level the unit.
Merchandising Decal
Self-adhesive merchandising decals are available to promote
food products. The decals are designed to be installed on
three (3) sides of the cabinet above the glass panels.
Decal Installation
1. Before installing decals, clean the side panels with a
nonoily cleaner, such as isopropyl alcohol (rubbing alcohol).
2. After the cleaned surfaces have dried, remove the
protective backing from the decal and apply to the panel.
3. Any air pockets or bubbles behind the sticker can be
removed by rubbing gently with a soft cloth from the center
towards the outer edges.
Form No. FSDCEM-1010
Corner Bracket
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Remove the lamp cover from in front of the fluorescent
lamp.
3. Carefully twist the fluorescent lamp and pull out to remove
it from the sockets on each end.
4. Align the tabs on each end of the new fluorescent lamp with
the channels on each socket, and push the lamp into the
sockets.
5. Carefully twist the fluorescent lamp in the sockets until it
"snaps" into position.
6. Replace the lamp cover in front of the fluorescent lamp.

oPTIoNs aND aCCEssoRIEs

Figure 13. Decal Installation
Merchandising Display sign Holders
Merchandising Display Sign Holders are available in heights of
3-1/4" (83 mm) and 7-1/2" (191 mm). The sign holders include
a metal holder and an acrylic window. Up to three sign holders
can be installed on a unit, one per side (excluding the control
side).
Printed signs are available separately to promote Pizza or
Chicken food products.
1. Remove the existing screws securing the top cover in
place, position the sign holder over the screw holes, and
reinstall the screws.
2. Place the printed sign in the holder and slide the protective
acrylic window over the sign.
Figure 14. Merchandising Display Sign Holder
(3-1/2" [83 mm] height shown)
Motorless Rack Coupling
The motorless rack coupling allows the stationary installation of
a circle rack or pretzel tree in cabinets that do not have a rack
motor (FSD-1X, FSDT-1X,FSD-2X, FSDT-2X).
13
MaINTENaNCE
Decal