Emtec EKCOH180 Manual Del Usuario página 10

GB
1. Press and hold SETUP (4) until the LED indicator (1) lights steadily. Release
SETUP.
2. Press and hold MUTE (10) until the LED (1) blinks once. Release MUTE.
3. Press once on the mode key (TV, VCR, ...) corresponding to the device whose
volume will always be controlled by the VOL (8) and MUTE (10) keys.
4. Press the VOL-(8) key once.
5. Press the MUTE (10) key once.
10) Problems and troubleshooting
The remote doesn't work or loses codes entered
· Confirm with your original remote that the equipment works
correctly.
· Make sure that you have pressed the corresponding mode key of
the equipment or device that you want to control.
· If the listed code does not work , try the AUTOSEARCH method
or enter the next code of that brand.
· To find the corresponding code for your equipment use the automa-
tic search.
· Check that the batteries have the correct polarity position.
· The programming of the remote requires 2 AAA alkaline batteries
(new). If the remote loses codes within a few days/weeks the problem
can be solved by using 2 new batteries from the same brand.
· If the LED is lit permanently, in general it will be necessary to
replace the batteries.
Important:
The 8 in 1 Universal Remote Control must be used only in the way
described in this instruction manual and may not be used for a purpose
not intended.