Publicidad
Idiomas disponibles
Idiomas disponibles
• Do not use appliance until leak checked.
• If you cannot stop a gas leak, immediately close LP tank
valve and call LP gas supplier on your fire department!
Appliance must be leak checked outdoors in well-ventilated
area, away from ignition sources such as gas fired or
electrical appliances. During leak test, keep appliance away
from open flames or sparks.
Setup Using Disposable Bottle
1. Make sure burner valves are off.
2. Remove plastic cap from top of propane cylinder. Save cap for
use in storing. Screw propane cylinder into regulator. Be
careful not to cross thread. Hand tighten only.
3. Check the connection between the cylinder and the regulator
with soapy water. Bubbles indicate a leak. Check that the
connection is not cross-threaded and that it is tight. Perform
another leak check. If there is still a leak, remove the
cylinder and contact the manufacturer for service or repair.
4. The regulator uses a threaded fitting to attach to the stove. It
is necessary to hold the stove to make sure the fitting is
seated. Align the regulator to the fuel tube on the rear of the
stove and push on. Screw on the outer threaded sleeve in a
clockwise direction until tight.
Leak Check
WARNING
WARNING
5. Never operate stove with propane cylinder in an inverted
position.
Dismantling Disposable Propane Cylinder
1. Turn all valves to the off position and make sure all flames
are extinguished.
2. Remove the bottle from the regulator by turning counter-
clockwise.
• Use appliance only with LP (propane) gas and the regulator/
valve assembly supplied.
• Installation must conform with local codes, or in their absence
with National Fuel Gas Code, NFPA 54/ANSI Z223.1. Handling
and storage of LP cylinders must conform to LP Gas Code
NFPA/ANSI 58. Appliance is not for use in or on recreational
vehicle and/or boats.
• Do not modify this appliance. Modifications will result in a
safety hazard. Questions regarding certification in other areas
may be addressed to 1-800-650-2433.
• Apartment Dwellers: Check with management to learn the
requirements and fire codes for using an LP Gas appliance at
an apartment. If allowed, use outside on the ground floor with
a 10 foot clearance from walls or rails.
• Before opening LP tank valve, check the coupling nut for
tightness. When appliance is not in use, turn off control knob
and LP tank valve on supply cylinder.
• Never use LP tank if visibly rusted, damaged, or out of date.
• If you notice grease or other hot material dripping from
appliance onto valve, hose or regulator, turn off gas supply at
once. Determine the cause, correct, clean and inspect valve,
hose and regulator before continuing. Perform a leak test.
• The regulator may make a humming or whistling noise during
operation. This will not affect the safety or use of appliance.
• Clean and inspect the optional bulk tank hose before each
use of the appliance. If there is evidence of abrasion, wear,
cuts or leaks, the hose must be replaced prior to the appliance
being put into operation. See product tag for hose & regulator
information.
• Never operate appliance with LP tanks out of correct position
specified in Assembly Instructions.
5
Publicidad
