Jeep Trek Easy-Travel Hoja De Instrucciones página 12

P25J-T:P25J-T.qxd 11/14/2007
To Assemble Changing Table
2
1
2
10:49 AM Page 12
NEVER place Changing Table on
unit if a child is in the Playard or
Bassinet.
IMPORTANT: Make sure Playard is fully
assembled with Floor Pad in place.
Find the curved side of the Changing Table .
1
Position the curved end of the changing
2
table next to the storage compartment
along the top rails of the Playard. Press the
clips downward onto the top rails until the
Changing Table locks in place.
NOTE: You may need to adjust the Bassinet
clips near the storage compartment to
accommodate the Changing Table. The
Changing Table MUST be assembled with the
curved end next to the storage compartment.
Pull up on the Changing Table to ensure it is
3
secure.
To Attach Toy Bar
(select models)
• Possible entanglement or strangulation
injury. Remove Toy Bar from Playard
when baby begins to push up on hands
and knees. Recommened use from birth
to 3 months or 15 lbs.
• Keep toys out of baby's reach. Toys are
not intended to be mouthed by the
baby.
• Always check to ensure Toy Bar is
securely attached. Check frequently.
• Do not add additional strings or straps
to attach to any other crib or Playard.
Press the Toy Bar clips down over
1
Playard rail or Bassinet clips, as pictured.
Attach the Soft Toys to the Velcro straps
2
on the Toy Bar. Each Soft Toy has a
Velcro patch.
12
(select models)
WARNING
WARNING