Dimplex DFR2651L El Manual Del Propietario página 10

Operation
C. Heat ON/OFF
Cycles the unit sequentially
through the 3 settings: Low Heat,
High Heat and Off.
→ Activated by pressing the
button on the unit or the remote.
• Indicated by the
or the (high heat) icon and
the intake temperature being
displayed on the On Screen
Display, for 5 seconds before
turning off.
! NOTE: After the heater is
switched off, there is a 60 second
fan delay, where the fan will
continue running before turning
off.
! NOTE: The unit can be
operated in Heat Only Mode.
When the unit is only running
with the heater, the
heat) or the
and the intake temperature will
continuously be displayed on the
On Screen Display.
! NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial heating
of internal heater.
10
(low heat)
(low
(high heat) icon
D & E. Thermostat Controls
Adjusts the temperature set point
to your individual requirements.
Once the desired set temperature
is reached the heater will turn
off. The heater will cycle on
and off to maintain the desired
set temperature. The default
temperature setting is 72°F
(22°C).
→ Adjusted by pressing the
to decrease the setpoint and
the to increase the setpoint
on the remote.
• The On Screen Display will
indicate the temperature
setpoint as it is adjusted.
! NOTE: Holding the
down, then press
will change the temperature from
°C to °F, or vice versa.
Disable Heat
If desired, depending on the
season, the heater on the unit
can be disabled. The unit will
operate in the same fashion, with
remainder of the controls.
Pressing the
on the unit at the same time and
button
on the unit,
and buttons
www.dimplex.com