Environmental Protection - Ryobi R18S18G Traducción De Las Instrucciones Originales

■
After using the product in the contact actuation mode,
switch it back to the full sequential mode.
■
The driving depth of the fastener may be adjusted
beyond air pressure. It is advisable to test the depth on
a scrap workpiece to determine the required depth for
the application.
■
Only fasteners matching the description in the product
specifications table can be used with the product.
Using incorrect fasteners may lead to jamming or other
malfunctions.
DEPTH ADJUSTMENT SAFETY WARNINGS
■
Always remove the battery before adjusting the depth
of drive wheel.
■
Do not pull back on the adjustment wheel. The wheel is
designed to be rotated.
■
Do not press the trigger while adjusting the depth of
drive wheel.
■
Always select full sequential firing mode before
adjusting the depth of drive.
■
Do not point the product towards yourself or anyone
nearby when adjusting the depth of drive.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps
or tape. Do not transport batteries that are cracked or
leaking. Check with the forwarding company for further
advice.
MAINTENANCE
WARNING
The product should never be connected to a power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
accidental starting that could cause serious injury.
■
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
■
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
■
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
2
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
■
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
■
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
LUBRICATION
All of the bearings in the product are lubricated with a
suffi cient amount of high grade lubricant for the life span of
the product under normal operating conditions. Therefore,
no further lubrication is required.
Do not use lubricants on staplers, magazine or driving
mechanism. Keep clean.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging
environmental-friendly recycling.
SYMBOLS
Safety alert
CE conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Please read the instructions carefully
before starting the machine.
Depth adjustment
Full sequential actuation
Contact actuation
Ga Fastener gauge
Diameter
Fastener width
English
should be sorted for