Before You Begin; General Safety Information - MaxLite MPulse MP Serie Manual De Instalación

Luminaria para cubiertas, dispositivo para montaje en superficie
Ocultar thumbs Ver también para MPulse MP Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
Risk of fire or electric shock. Luminaire wiring and electrical parts may be damaged when drilling for
installation of led retrofit kit, check for enclosed wiring and components.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.

General Safety Information

• To reduce the risk of death, personal injury or property damage from
fire, electric shock, falling parts, cuts/abrasions, and other hazards
read all warnings and instructions included with and on the fixture
box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires
should be performed by a qualified licensed electrician.
• DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and
grounded UL listed junction box.
WARNING:
RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code
and any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing
or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustable and other materials that can burn away from luminaire and lamp/lens
• Do not mount to flammable or combustible surfaces.
Input Rating: 120V-277V 50/60Hz
Operating Temperature: -40°F to 122°F
Illustrations in the manual are for installation purposes only. It may not be identical to the fixture purchased.
Models:
This instruction manual applies to the MP-CP Series
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
BEFORE YOU BEGIN
Read these instructions completely and carefully.
© Copyright 2018. MaxLite, Inc. All Rights Reserved.

Publicidad

Tabla de contenido
loading

Productos relacionados para MaxLite MPulse MP Serie

Este manual también es adecuado para:

Mpulse cp serie

Tabla de contenido