Assembly - REV Ritter JY-229 Manual De Instrucciones

B
Figure of the camera
1 13
Camera lens
1 14
Channel selection display
1 15
Channel selection switch
1 16
Power unit connection 9V, 500mA
1 17
Mounting ring
1 18
Engagement hook
1 19
Mounting hole
1 20
Covering hood
Infrared (IR) light source
1 21

Assembly

Look for a suitable installation place, from where the desired
object can be monitored. A reduction of range owing to
construction restrictions can frequently be strongly influenced by
slight variation of the installation position. Avoid installation on
metal surfaces or on reinforced concrete. These materials shield
radio waves and hence reduce the range.
The camera is suitable for ceiling and wall installation. You can
also place the camera on a solid surface (e.g. cupboard, table
etc.).
1. Remove the installation ring from the bottom of the camera
(Fig. 1).
2. Fix the installation ring by means of the accompanying
screws on the desired position (Fig. 2).
3. Select one of the four channels (15) at the bottom of the
camera (see the item "channel selection on the camera").
19