How To Charge; Technical Data - Adler europe AD 2813 Manual De Uso

DETAILED SAFETY RULES
1. Blades are very sharp. Be careful when removing any accessories or cleaning hair clipper. Never touch
blades when they are working.
2. Do not use hair clipper longer than 10 minutes. After this period of time hair clipper should be turned off for
a 5 minutes before continue of work.
3. Never charge batteries longer than 48 hours.
4. Never recharge the battery when temperatures are below 5deg C or above 40deg C.
5. Never put the clipper into water (pic. 2).
PRODUCT DESCRIPTION (pic. 1)
a) blades b) switch
d) power socket e) comb attachment

HOW TO CHARGE

Before first use:
1. Plug one end of the A/C Adaptor into the shaver and the other ent to an electrical outlet (230V, ~50Hz).
2. The indicator light (pic. 1 c) will light to indicate the unit is charging.
3. Unplug the A/C Adaptor from the unit and the electrical outlet before using.
First charging takes 12 hours, next 8 hours.
USING HAIR CLIPPER
Put the guard attachment on the blade, this guard attachment can have 7 height adjustments which can be
adjusted by moving this guard up or down. Once the correct hair adjustment is set according to the required
number from 1 to 7, then push up the button (pic. 3) on the back of the unit to LOCK the guard, so while
cutting har the guard does not move from fixed length.
CLEANING AND MAINTENANCE (pic. 9)
To dismount the blade please push its upper part away from the housing. Follow the direction shown in the
picture 5 and 6. Then clean the blade block using brush attached. In order to remove hair which may be left
between blades depress the cleaning hook and open it. After every few uses of the unit please put 2-3 drops
of oil between stationary and moving blades. For reasembling set the cut indicator and push the blade as it
shown in the picture 7 and 8.

TECHNICAL DATA:

Power: 2W
Voltage: 220-240V~50Hz
charging time: 8 hours
ALLGEMEINE VORSICHTSMAßNAHMEN
1. Schermesser sind sehr scharf. Bei der Montage, Demontage und der Reinigung des Gerätes spezielle
Vorsicht bewahren. Bewegliche Klingeelemente während der Arbeit nicht berühren!
2. Das Gerät nicht länger als 10 Minuten benutzen. Nach Ablauf dieser Zeit das Gerät für cirka 5 Minuten
ausschalten. DEN AKKU NICHT LÄNGER ALS 48 STUNDEN AUFLADEN – dies kann unumkehrbare
Beschädigung verursachen.
3. Aufladeprozess soll bei Temperaturen zwischen 5 - 35 Celsiusgrad stattfinden.
4. Klingen nicht im Wasser reinigen (Abb. 2)
BESCHREIBUNG DES PRODUKTES (ABB. 1)
a) Klingen b) Ein-/Ausschalter c) Ladeanzeige
d) Ladestation e) Kammaufsatz
ENGLISH
c) charging indicator
Device is made in class II of isulation.
Device is compliant with EU directives:
- Low voltage directive (LVD)
- Electromagnetic compatibility (EMC)
Device marked CE mark on rating label
DEUTSCH
44
l