Canyon CND-GPW3 Manual De Instrucciones página 4

Operation modes LED:
If the controller is paired when the battery voltage is lower than 3.5 V, the LED will
flash to indicate low power warning and the vibration function will not work.
PC Xinput / Dinput wired mode connection Settings:
1. Connect the USB cable directly to the computer USB port.
2. If the connection is successful the LEDs will remain on.
3. LED1+LED4 - Xinput mode / LED1+LED3 - Dinput mode.
Android wireless / wired mode connection Settings:
There are 2 connection modes: 1) Wireless mode: connect the receiver via the
OTG line 2) Wired mode: connect the receiver via the OTG cable directly to the USB
port of the phone, LED2 + LED 3 lights will turn on to indicate that the connection
is successful, if they do not illuminate, hold the HOME key for 5 seconds until they
turn on.
Note:
1. The mobile phone or tablet must support the OTG function and use the OTG
cable connection.
2. The current Android version does not support the controller vibration function.
Channel LED indicators:
If the controller is paired,when the battery voltage is lower than 3.5V, LED2+LED3
will flash to indicate low power.
Nintendo switch connection/pair Setting:
1. On your «Nintendo»,select the menu item Controller - Change Grip and Order.
2. Insert the receiver directly into the USB 2.0 port.
3. Press the «HOME» button, LED1, LED2, LED3, and LED4 will flash when paired.
When the LED(s) remain on, the connection is successful.
OTG CABLE
Receiver