AUtec E16 Serie Manual De Instalación Y Funcionamiento página 21

H
A
F
POWER:
STOP/ENABLE:
SAFETY:
START/ :
RL1 - RL14:
Six commands may be added to those already incorporated in the receiving unit, by means of an additional
command unit.
To connect the additional command unit to the receiving unit:
- remove the cover on the bottom right (see photo)
- insert the extension connection cable into the connector on the receiving unit (see photo)
LIKTCIU2
2.5 Receiving unit
L
indicates power supply is on
indicates radio link between the transmitting and the receiving units
Indicates the SAFETY function is activated
indicates the START function is on
indicates that the relay for the corresponding command is activated (see the KTC
technical card)
Additional command unit
M
D
A Power supply terminal block
B Technical data plate
C
C Identification plate
D Output terminal blocks
F Openable cover
G Antenna connector
H Fuses
L Light signals
B
G
Light signals
D
D Output terminal blocks
M Connection cable
additional
command
unit
ENGLISH
Page 17