Dr 5650 Desoldering Iron - jbc DR 5650 Manual Del Usuario

ENGLISH
We appreciate the trust you have placed in JBC by purchasing this DR 5650
desoldering iron. It has been manufactured with the strictest quality standards in
order to give you the best possible service.
Before using this equipment, we recommend you read these instructions carefully.

DR 5650 DESOLDERING IRON

Includes the following:
- DR 5650 desoldering iron ref. 5650000 with
the 5600-003 tip ref.5600003.
Power desoldering iron: 75W.
- Set of accessories ref. 0780593 with tips for
the desoldering iron: 5600-013, 5600-004 and
5600-005.
- Instructions manual.
This product should not be thrown in the
.
garbage
Electric desoldering pump
MS 9024 Ref.9024000
Air pressure desoldering system
MS 9025 Ref.9025000
Spare filters
Ref.0781046
External desoldering
air filter Ref.0821830
DR 8500
desoldering iron stand
Ref.0788500
Heating element
Ref.5650010
Spare filters
Ref.0005966
DR 5650
desoldering iron
Ref.5650000
Desoldering process
Use the tip model with a larger diameter than
the pad to be desoldered, so as to achieve
maximum aspiration and thermal efficiency.
1 Apply the desoldering iron tip so that the
component terminal penetrates within its
orifice.
2 When the solder liquefies, start gently to
rotate the desoldering tip so that the
component's terminal can be eased away
from the sides.
3 Press then, not before, the vacuum pump
push-button just long enough to aspirate
the solder.
1 2
After pressing the desoldering key there is a
slight delay until the self-contained vacuum
pump stops, this is to make sure that the
vacuum circuit is completely empty.
If any solder remains are left on any terminal
after attempting to desolder it, resolder it with
fresh solder and repeat the desoldering
operation.
Tip care
- The largest rod that fits in the tip hole should
periodically be passed through in order to
clean the intake tube.
- To clean the tips, use the sponge included
with the stand and check it is slightly
moisted.
Only deionised water (car battery water) Only deionised water (car battery water) Only deionised water (car battery water) Only deionised water (car battery water) Only deionised water (car battery water)
should be used in order to wet the sponge should be used in order to wet the sponge
should be used in order to wet the sponge should be used in order to wet the sponge. should be used in order to wet the sponge
If normal water was to be used, it is very
likely that the tip will become dirty due to the
salts dissolved within the water.
1
3