Operating; Clearing The System In The Event Of A Lost Or Stolen Transmitter - Vetus REMCO1 Manual De Funcionamiento E Instrucciones De Instalación

4 Operating

1 Turn on the main power to your thruster system.
Although the remote control will work independent from the dash/instrument
panel fixed thruster control panels we recommend for safety reasons to turn
on at least one of your fixed thruster control panels (joystick or rocker
switch).
 Hold down both large buttons on any transmitter for five seconds. Your remote con-
trol system is now turned on. To conserve transmitter battery power, your system
will turn itself off after ten minutes without use. Hold down both large buttons of any
transmitter again, for five seconds, to turn the system back on.
3 To turn the remote control system off at any time, hold the two smaller button of any
transmitter down for five seconds.
4 With the system turned on,
operate and control your
thruster(s) by simply push-
ing, holding and releasing
the appropriate button(s) of
a transmitter. The bow and
stern thruster may be oper-
ated and controlled simul-
taneously by pushing the
appropriate buttons on a
transmitter.
5 Clearing the system in the event of a lost or stolen transmitter
1 Turn the power on to your thruster system
 Open the access panel that provides access to the underside of your dash/instru-
ment panel and locate each receiver of your Vetus thruster remote control system.
1
0601.01
vetus®
Radio Remote Control