Price Pfister Wakely 34 Serie Manual Del Usuario página 3

7
7C
7A
7D
7E
7 SECURING DECKPLATE TO DECK
From underneath sink, hand tighten Wing Nuts (7A) to Mounting Posts (7C). Remove
any excess putty from around the outside edge of Deck Plate (7B). From underneath
sink, secure the faucet by placing the Metal Washer (7D) and the Long Nut ( 7 / 16 Hex.)
(7E) onto the Mounting Post (7F). Make sure that the bumps on the Metal Washer (7D) are
facing up. Tighten using a flathead screwdriver or an adjustable wrench until the faucet is
firmly connected to the sink. Do not over tighten!
8
8 HOSE GUIDE INSTALLATION
Insert Hose Guide Shank (8A) through Flange Gasket (8B) and into the sink hole.
From underneath sink, secure Hose Guide (8A) by screwing Plastic Locknuts (8C).
Hand tighten.
Caution: do not over tighten!
7B
7F
7C
7A
8A
8B
8C
ENGLISH
9
9 SIDE SPRAY INSTALLATION
Insert Side Spray Hose (9A) through Hose Guide (9B).
10
10C
10B
10 HOSE CONNECTION
From underneath sink, push Quick Connect Housing (10A), located on the end of the Spray
Hose (10B), firmly upward onto the receiving Tube (10C), until unable to push any further.
Pull down on the quick connect housing (10A). If the housing and the Inner Collet (10D)
separate slightly, do not pull off the receiving Tube (10C), quick connect is secure.
11
11D
11B
11C
HOT
11 WATER SUPPLY LINES
Gently separate hot and cold supply tubes (11A), approximately three inches apart.
Connect water Supply Lines (11C) to Faucet Inlets (11B). Hot water supply line goes to hot
inlet fitting indicated by red tag (11D). (Supply lines not included). Follow manufacturer's
instructions when installing supply lines. Do not twist Inlets (11A)!
3
10D
10C
10A
11A 11A
11B
11C
COLD
9A
9B
10B