Blue Tooth Handfree System - Lenco CS-455 BT Manual De Instrucciones

Blue Tooth Handfree System

1. Pair
To pair your mobile phone with a Bluetooth device, simply activate the Bluetooth function on your mobile
phone and search for devices. When the stereo has been found it should show as Car Kit, when you try to
connect, it will ask for a password.
The default password is 0000. When you have successfully paired your phone the message BT READY will
be displayed followed by the mobile number. When the phone has successfully connected you will see a
blue led on the display flashing.
This LED will turn to solid when you are on a call or disappear when you disconnect from the stereo.
2. Connection or disconnection
A) Use the mobile phone to do connection or disconnection
1) In the connection status, find the paired and connected Bluetooth Device, then press the
disconnection button to do disconnection.
2) In the disconnection status, find the paired and disconnected Bluetooth Device, then
press the connection button to do connection.
B) When turn on the power again(after Acc off ), the front panel can search the phone have pair
automatically and be connection. And it will take you about 20 seconds.
3. Accept/Reject/Hold/End Call
Accept - Press the 5(-10,HAND UP) button
Reject - Press the 6(+10,HOLD)button
4. Talking volume level setting
At talking status, use the VOL knob to adjust the sound output, but this volume level can not be reserved.
Note: the default volume level is 25.
5. To transfer the audio of a file played by Mobile Phone to the Car Audio Player
If the mobile phone supports A2DP and could play audio, when the Mobile Phone plays an audio file(For
some Mobile Phones, you must select Play by BT firstly), the playing will be transferred to the Car Audio
Player.
In A2DP mode, if the Bluetooth device of the Mobile Phone support AVRCP, the functions of the >>|, |<<
and PLAY/PAUSE buttons are the same as one in disc mode(no fast forward /backward functions for
the >>|/|<< buttons). The other buttons available in disc mode are not available.
In A2DP mode, if the Bluetooth device of the Mobile Phone support AVRCP, pressing the MODE button can
switch on between the radio, disc, USB, CARD and A2DP. But after entered the A2DP mode again, to
resume the playback and transfer to the Car Audio Player by the Mobile Phone, you must press the
PLAY/PAUSE button.
In A2DP mode ,if the phone music play mode turn to the radio mode, you need to wait about 10 seconds.
8