Switching On/Off The Unit; Faceplate Release; Sound Adjustment; Display Information - Lenco CS-420 Manual Del Usuario

OPERATION

SWITCHING ON/OFF THE UNIT

Press PWR button (2) to turn on the unit.
When the unit is on. Press and hold for 2
seconds to turn off the unit.

FACEPLATE RELEASE

Press release button
removable faceplate.

SOUND ADJUSTMENT

Press SEL button (3) shortly to select the
desired adjustment mode. The adjustment
mode will be changed in the following
order:
BAS-TRE-BAL-FAD-BEEP-EQ- LOUD-LOC-STEREO
-AF- REG -TA-TA VOL -EON-VOL
BAS: bass
TRE: treble
BAL: balance
FAD: fader
BEEP: beep on/off
equalization
EQ:
loudness
LOUD:
LOC: local
STEREO: stereo
AF: Alternative Frequencies
REG: Region
TA: Traffic Announcement
TA VOL: Traffic Announcement volume
EON: Enhanced Other Network
VOL: volume
By rotating the audio knob (3) it is possible
to adjust the desired sound quality.
LOUDNESS FUNCTION
In LOUD item you can turn on/off loudness
function.
LOC on/off
In this item rotating the audio knob (3) to turn
on/off local function. In LOC ON mode the unit
will reduce the receiving sensitivity when
you search station. That means you can
receive the station that sound is good. It will
ignores the station that sound is not good.
In LOC OFF mode it will increase the
receiving sensitivity when you search the
station. That means you can receive more
(19) to detach the
stations.

STEREO/MONO function
Press SEL knob several times till appear
"STEREO". Rotating the audio knob (3) to
select STEREO or MONO mode. In STEREO
mode you can receive FM stereo signal. In
MONO mode the stereo station will be
switched to
when the signal is not good. If you change
it to MONO mode. The noise will be
reduced.
TA volume
This function allows you to define the
minimum volume
announcements. The adjustable range is
20~43. The defaulted value is 26.
Rotating the volume knob to adjust the
volume of the traffic.

DISPLAY INFORMATION

Press DISP button (17) to show the time for
several seconds. After several seconds it
will return to show the information.

SET THE TIME

Press and hold DISP button for 2 seconds.
The hour of the time will be flashing. Press
/ button to set the correct hour.
Press DISP button shortly to change to
minute. Also use
correct minute. After that press SEL button
to confirm.

LIQUID CRYSTAL DISPLAY

Exhibit current frequency and activated
functions on the display .

AUXILIARY INPUT

The unit can be connected to a portable
audio player through the AUX IN jack (7).

RESET FUNCTION

RESET button (8) must be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for the
following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
9
monochrome. Sometimes
for the
/ button to set the
traffic