Safety Instructions - Holiday SL-4046-RC Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

_______

Safety instructions

:
WARNING:
result in electric shock, fire or serious personal injury. The warnings, cautions, and instruction
discussed in this instruction manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense and caution are a factor which
cannot be built into this product, but must be supplied by the operator.
CAUTION:
A short power supply cord is provided to reduce the risk of personal injury resulting from
becoming entangled in or tripping over a longer cord. Extension cords are available from local
hardware stores and may be used if care is exercised in their use. If an extension cord is required,
special care and caution is necessary. Also, the cord must be: (1) marked with an electrical rating of
125V, and at least 13 A., 1625 W., and (2) the cord must be arranged so that it will not drape over
the countertop or tabletop where it can be pulled on by children or tripped over accidentally.
Polarized plug
NOTE:
This projection light has a polarized plug (one blade is wider than the other).
As a safety feature to reduce the risk of electrical shock, this plug is intended to fit in a polarized
outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug.
If the plug still does not fit, contact a qualified electrician. Do not attempt to defeat this safety
feature.
Electric power
If electric circuit is overloaded with other appliances, your projection light may not operate properly.
The projection light should be operated on a separate electrical circuit from other operating
appliances.
Safety warning
Although your projection light is easy to operate, for your safety, the warnings below must be
followed:
1.
Do not place the projection light near a heat source.
2.
Use the projection light on a stable surface away from water.
3.
Do not unplug from the power outlet by pulling on the supply cord.
4.
The projection light must be unplugged:
A.
After each use.
B.
If it appears to be faulty.
C.
Before cleaning or maintenance.
CAUTION:
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
CAUTION:
The use of optical instruments with this product will increase eye hazard.
Do not attempt to repair or disassemble the laser. If unqualified persons attempt to repair this laser
product, serious injury may result. Any repair required on this laser product should be performed by
authorized service center personnel.
THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY. SAVE THESE
4
___
Read and understand all instructions. Failure to follow all instructions listed below may
_______
INSTRUCTIONS!
___Assembly

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido