Black Max BM3716 Manual Del Operador página 21

BUCKING
See Figure 23.
Bucking is the term used for cutting a fallen tree
to the desired log length.
 Cut only one log at a time.
 Support small logs on a saw horse or another
log while bucking.
 Keep a clear cutting area. Make sure that no
objects can contact the guide bar nose and
chain during cutting, this can cause kickback.
To avoid the danger, keep the anti-kickback
device attached while cutting. Refer to Kick-
back in the Specific Safety Rules section of this
manual for more information.
 When bucking on a slope, always stand on the
uphill side of the log. To maintain complete
control of the chain saw when cutting through
the log, release the cutting pressure near the
end of the cut without relaxing your grip on the
chain saw handles. Do not let the chain contact
the ground. After completing the cut, wait for the
saw chain to stop before you move the chain
saw. Always stop the motor before moving from
tree to tree.
BUCKING WITH A WEDGE
See Figure 24.
If the wood diameter is large enough for you to
insert a soft bucking wedge without touching the
chain, you should use the wedge to hold the cut
open to prevent pinching.
NOTE: When bucking or felling with a wedge, you
may need to remove the anti-kickback device to
allow the bar to be drawn through the cut. After
you complete the cut, reinstall the tip.
OPERATION
Page 21 — English
KICKBACK
Fig. 23
WEDGE
Fig. 24