GRAFF AQUA-SENSE Instrucciones Para El Uso página 51

La pression de l'eau est basse.
La vanne n'est pas étanche.
(Attention : Risque d'électrocution
et d'endommager l'appareil.
Fermez le circuit d'eau et
débranchez du courant.)
Liste des problèmes (5)
Problem
Control function is normal,but
ow is unstable and decrease.
LED light is fading or not
working.
Is there any problem with the product? Please check followings before requesting the Service.
System error diagnosis
Problem
IOG 5105.36.1
La vanne est-elle connectée
correctement et assure l'étanchéité?
Y a-t-il de l'eau dans l'appareil?
Est-ce que le ruban de Té on ou
le joint sur les raccordements est
endommagé ou bien se détache?
Speci c situation Recommended action
Is water supply valve shut o ?
Has water pressure dropped over
time?
Is water being used elsewhere while
T-Shower is in use?
Is white acrylic shower head cover
contaminated?
Does LED light work?
Speci c situation
Temperature Sensor Error
Temperature Motor Locking
The connector is o or the line is
disconnected
Thermistor Problem
The connector is o or the line is
disconnected
Water supply is not available
Boiler Problem
Hot water supply is not available
Temperature Sensor Error
Temperature Motor Locking
The connector is o or the line is
disconnected
Flow Sensor Problem
Connector is o or line is disconnected
CONTROL TOUCH PANEL
Véri ez l'état de tous les raccordements et réparez-les en cas
de besoin. Il convient de véri er en détail l'état technique de
l'appareil. Débranchez l'arrivée d'eau et d'électricité, puis contactez
le service après vente.
Véri ez que le ruban de Té on ou les joints ne sont pas
endommagés au niveau du raccordement qui fuit.
En cas de besoin, remplacez le joint.
Check valve at supply valve.
Clean lter at water supply valve(refer to page 7)
Check to see if volume ow meets the minimum
requirement of 2.0bar.
Check to see if water pressure of the pipe to control box
is 2.0bar or more.
Shut o power and clean by removing.
Check to see if cable between wall pad, control box
and shower head is disconnected or loose?
Refer to "Cable layout " part of T-Shower user manual.
(Page 35)
Recommended action
Disconnect the power cord, then connect again.
Make sure the connector is in right position.
Check if hot/cold water is correctly supplied.
Make sure the connector is in right position.
Check the inlet pipe of cold water.
Check if the boiler has a problem.
Disconnect the power cord,then connect again.
Make sure the connector is in right position.
Check if the ow connector is connected.
Check if the line is disconnected.
12 Rev. 2 March 2012