Casals VMP800M Manual Del Usuario página 7

stop If the model of your appliance does not have
the the accessories described above, they can
e on also be bought separately from the Technical
Assistance Service.
aces
ster, Installation
utility Auxiliary Operation (Fig 1)
l the
ntact - Operate the appliance only with the
ectric auxiliary handle.
d to - Turn the auxiliary handle (F) in clockwise.
uses - Set the auxiliary handle on the appliance
ectric into the required position.
- Tighten the auxiliary handle (F) in counter
ately clockwise direction.
hot
rious
Instructions for use
aged Before use:
d pill - Make sure that all the product's packaging has
been removed.
- Prepare the appliance according to the
avoid function you wish to use:
Fitting the working tools: (Fig. 1, 2)
ons - Unplug the appliance from the mains.
- Only use tools with SDS-plus shaft.
- Clean and grease the shaft of the tool.
- Insert the tool by moving the sliding ring (B)
back. Now the SDS-plus chuck is open.
- Install the tool in. Turn it slightly until it can
be pushed in all the way and you can feel it
engages into place.
- Release the sliding ring (B). Now the tool is
locked.
SDS-plus adapter for drilling in wood or
metal (Fig. 3)
- Unplug the appliance from the mains.
- Fit the SDS-plus adapter (K) into the SDS-plus
chuck as described above "fitting the working
tools"
- Screw the Drill Chuck (J) on the mounting shaft
and Screw the mounting Screw.
- Open the drill chuck (J), whilst the device is
completely switched off.
- Insert the cilindrical drill bit, or other tool/
accessory required for the task, into the chuck
(J). In order to obtain a secure fastening of the
bit, insert the bit as far as you can into the chuck.
- Close the drill chuck (J), whilst the device is
completely switched off.
- Don't use rotation with hammering when the
SDS-plus adaptor + drill chuck is installed on
the device.
Using the dust collector (Fig 2)
- The dust collector is used for drilling into
ceilings.
- Side the dust collector (I) onto the shaft of
the bit and mount the bit as described above
"Fitting the working tools".
Use:
- Connect the appliance to the mains.
- Select the appliance function desired
(Fig 1)
Hammer drilling with rotation
- Set the selector (D) to (
- Turn the selector (C) until the arrow on the
appliance points to (
Drilling without hammer action
- Set the selector (D) to ( )
- Turn the selector (C) until the arrow on the
appliance points to (
Chisel without rotation
- Set the selector (D) to (
)
)
)
)
7