IIC bus error
1IC100 TDA9321H
1TU1 CTF5510
1IC200 SDA6000
63IC1 TDA8722M
64IC2 TDA7315
6IC2 H8/3216
32IC601 H8/3214
1IC550 MSP3410D
1IC350 TDA9330H
1IC300 TDA9178
1IC49 PCF8563
On modes:
Data failure (DF)
ML error codes are for detection of errors in the Master Link system.
. . . .
No error registered
CI
Address confi guration impossible
TD
ML data pulled down
TU
ML data pulled up
??
Other undefi nable error possibilities
NH
No Hardware. There is no Master Link PCB in the TV
AVL error codes from the V.TAPE and AV sockets
. . . .
No error registered
TI
Transmission impossible
TD
Data link tied down
Motorized stand error codes
ST-01
Calibration error too few positions
ST-02
Calibration error too many positions
ST-03
Calibration error EEPROM
ST-04
Calibration error transducer
ST-05
Calibration error position
After repair of an error that has triggered the display of an error code, the error code
has to be deleted. This is done by pressing GO in the MONITOR INFORMATION menu.
An IIC bus error means that the communication on the bus fails when the
microcomputer tries to communicate with the address in question.
In most cases this means that the addressed IC is defective but the defect could
also be in one of the components surrounding the IC or in other components on
the bus. Adresses in connection with IIC bus errors:
IC
Function
Colour decoder & IF (HIP)
TV tuner
M2 Processor
Modulator
Power Link
IOP Main processor
Digital Sound AC3
Sound processor
Video processor (HOP)
CTI
Real-time clock
S - Standby mode
A - Audio mode
V - Video mode
If an error occurs in the EEPROM (6IC6) that prevents output of geometry data to
the TV set, the microcomputer will replace the missing data with default data
stored in the EPROM (6IC3) module 999.
Service Mode, English
On modes
Adr
Clock
AV
8A
100 kHz
V
C0
100 kHz
AV
22
400 kHz
AV
C8
100 kHz
AV
80
100 kHz
SAV
60
400 kHz
AV
84
100 kHz
AV
80
100 kHz
V
8C
100 kHz
V
40
400 kHz
S
A2
100 kHz
5.7
BUS
IIC-2A
IIC-2A
IIC-2D
IIC-2A
IIC-2B
IIC-2D
IIC1
IIC-2C
IIC-3_2
IIC-3_2
IIC1