MASTER AUDIO DESIGN TSL DIGITAL Manual Del Usuario página 34

Choosing the slot 0 with SET, the following screen is displayed:
At this point, if the event should be repeated every year, the question must be
answered with Yes, otherwise with No. Answering No implies that the event will
take place once, so an additional screen will prompt for the year in which the
event should occur.
After doing this, first the beginning date of the event and afterwards the finishing
date are introduced. Both are determined by day, month, hour and minute, as
seen in the following screen shots:
Bypass Date 0
On: 23/06 16:00
NOTICE: In the case that the "Off" date is previous to the "On" date, the TSL
assumes that the "Off" date refers to the next year, no matter if it is a repeated
or a single event. In the case of single events, the year introduced is taken as
the beginning year.
For instance, in order to bypass the TSL on New Year's Eve, this is how to
proceed:
Bypass Date 0
On: 31/12 16:00
Taking this into account, the interval during which it is possible to bypass the
TSL goes from 1 minute to 12 months.
Bypass Dates override the weekly program.
between the On and the Off date of a Bypass Date, the TSL remains bypassed.
The programmed Bypass Dates start to be valid as soon as the Function Menu
is left with the option "Exit CONFIG" and the main screen is displayed.
4. Adjust Levels:
The attenuation levels DAY and NIGHT can be adjusted by means of the
potentiometers located on the TSL front panel. These potentiometers are
accessed after removing the security seal. A detailed explanation about the
adjust method is given in the next section of this manual.
Bypass Date 0
Repeat (Y/N):N
Bypass Date 0
Year:03
Bypass Date 0
Off: 24/06 09:00
Bypass Date 0
Off: 01/01 09:00
33
When the current date is in