Sealing; Recommendations - MASTER AUDIO DESIGN TSL DIGITAL Manual Del Usuario

coming from the Mixer (>3V), thus activating the SIGNAL EXCESS circuit
(Fixed Red led indicator ON) and this situation is maintained for over ten
minutes . In this case, a total INTERRUPTION of the Signal will be produced
during a penalization time foreseen by the Regulations. To re-establish
normality you only need to decrease the signal level (volume) of the Mixer to the
point or Area set as maximum authorized power (Limiter active led blinking).
This function has been specially designed to prevent the musical Operator from
unnecessarily introducing Level Excesses coming from the Mixer Controls
(Gain, Tones and Master)) which will only allow the possibility of saturation and
distortion on the Musical Program on the air without any options of surpassing
the Limits established. This penalization must be understood as a guarantee for
the DJ, which will allow him to get a perfect audio response even with the
Limiter active permanently (blinking), that is, when working upon the limits
without danger of felling in the sad situation of Public Punishment before his
audience.
• The penalization time is internally adjustable between 5 and 60 sec (only
technicians).
• EXTERNAL LED INDICATOR: For its connection, a standard cable suitable
for a (balanced) microphone is needed, with STEREO 1/4" Jack connectors and
with the length necessary for each application. By using a relay, Triac or a
Dimmer, this output may be used to activate higher-powered light indicators.
The level is from 0-15 V.

6 - SEALING

The TSL offers the possibility of easily and softly Sealing all its Controls:
• At the front part, this is done with a simple movement of the sliding Covers
that hide all the adjustable areas of the System. Then a wire may be passed
through the Pivots foreseen for this purpose and the definite sealing may be
done using lead or any other method of sealing. The Clock's independent
Cover/Seal gives access to the Bypass position ("liberating" Official timetables
and Attenuation Levels) without modifying the preset Adjustments, whenever
the authorities allow this modification: Local Holidays, New Year's Eve, and so
on.
• At the back part, the Input and Output connections go directly to the printed
Circuit and are totally inaccessible. The Cover giving access to the internal
controls also include two Sealing points using the same Wire and Seal system
as above.

7 - RECOMMENDATIONS

The TSL must not introduce any anomalous situation regarding operation or
that may result in detriment of the good quality of music within the chain of
38