Rowenta DR81 Serie Instructivo De Operación página 28

IS THERE A PROBLEM ?
PROBLEMS
There is no steam.
The appliance
does not heat.
Water leaks.
Steam rate
decreases.
The steam leaves
stains on the fabric
or the appliance
spits.
Appliance steams
continuously.
28
POSSIBLE CAUSES
The appliance is not plugged in,
or not switched on.
The water level is too low.
The steam pump has not been
primed.
You are using the appliance for
the first time.
The water tank is not fully in
place.
The appliance is on standby
mode.
It is not plugged in, or not
switched on.
The appliance is on standby
mode.
The water tank is not fully in
place or the stopper is not closed
properly.
Calc Sealing.
You are using water with
additives.
The appliance has not been
cleaned enough after the
descaling operation.
You are using other liquids than
white vinegar to descale the
product.
The steam trigger is on the lock
position.
SOLUTIONS
Check that your appliance
is correctly plugged in and
switched on.
Unplug your appliance and refill it.
Press the steam trigger continu-
ously for a few seconds to begin
steaming.
Press the steam trigger continu-
ously for a few seconds to begin
steaming.
Ensure that stopper is closed and
that the water tank snaps when
put into place.
PLEASE REFER TO THE 'STANDBY'
section.
Plug in your appliance and
switch on.
PLEASE REFER TO THE 'STANDBY'
section.
Ensure that stopper is closed and
that the water tank snaps when
put into place.
Refer to 'ANTI CALC section in
instructions for use.
Never add any additive in the
water tank.
Read carefully the 'ANTI CALC'
section in instructions for use.
Use only white vinegar during
'ANTI CALC' procedure.
Unlock the steam trigger.