KTM Power Parts 60714910133 Manual De Usuario página 12

- Position the fuel tank.
- Mount screw with bearing sleeve and rubber bushing and tighten
to 15 Nm.
- Plug in connector .
- Mount vent hoses and .
- Mount cable tie(s).
- Mount screws with bushings on both sides and tighten to 10 Nm.
Mount switch
- Drill mounting holes (Ø 22 mm and Ø 5 mm) using appropriate tool.
NOTE
The positions are market on the trim.
When drilling, make sure that none of the components are dam-
aged!
- Position switch housing with switch (included).
- Route through the hole.
- Position clamp (included).
- Mount and tighten screws (included).
- Join plug-in connector together.
- Route the cable without tension.
Ensure that the cables are not kinked or pinched!
12